• All Files

Home > Online Help

Changing the default column setting on the policy page

The Policy & Objects > Policy > IPv4 window is one of the more important ones in the Web based interface and has the capacity to display a lot of information, but displaying all of that information at the same time makes for a very busy screen. If all of the columns are displayed, depending on the screen size you may have to constantly use the scroll bars to see what you need to look at. The default installation shows some of the more commonly used columns but these list may not consist of the columns that you wish to look at or the order that you wish to view them in. For this reason it is possible, through the CLI to override these settings to establish a new default.

The syntax of the command starts with:

config system settings

set gui-default-policy-columns

 

The rest of the command is a space delimited list that depends on the columns you wish to view and the order you wish to view them in. The possible selection is in the following table.

Variables for the gui-default-policy-columns command

Variable Name	Column Heading
#	Sequence Number
policyid	Policy ID
srcintf	Source Interface
dstintf	Destination Interface
srcaddr	Source Addresses
dstaddr	Destination Addresses
schedule	Policy Schedule
service	Policy Services
action	Policy Action
logtraffic	Traffic Logging Status
nat	Policy NAT Status
status	Policy Status
authentication	Authentication Groups
count	Policy Traffic Counter
profile	Security Profiles
vpntunnel	VPN Tunnel
comments	Policy Comment

Example

If you wanted these columns in this order, Policy ID, Source Addresses, Destination Addresses, Security Profiles, Policy Comment. You would enter the command:

config system settings

set gui-default-policy-columns policyid srcaddr dstaddr profile comments